EZ Shop
Brand New
Favorites
Clearance
Bestsellers
Designer Tools
News
Grant
FAQ
Corrections
Downloads
Article Archives
Site Map
Bead Shop
Catalogs
Coupons
Newsletters
Trend-E-Mails
Contact & About Us
Order Terms
International Terms
Términos y Condiciones
|
|
| |
Step 1: Lay out 3 strands of beading wire.
Step 2: Start in the center, run all 3 wires into the G64146 (saucer) the CH146MRO (carrots)
do this three times.
Step 3: Run the Three strands into the GC6 on both sides.
Step 4: Center strands get's 3 of the G142025 (2.5mm bead) .
Step 5: Center strand gets CH138MPE saucer G64146 - CH138MPE -G64146 - spacer TK186023 -
G64146 - CH138MPE -G64146 - G2142025.
Step 6: On out side strands use 2-G142025 then the GFCT24 - Tubes.
Step 7: run strand after 1st tube into the 3-strand spacer on both side repeat same pattern.
Step 8: Thread into G2.5 on both sides.
Step 9: Run all strands into the GC6 and G142025 and GFCT1 crimp onto the GF34 Toggel and Bar.
|
|