EZ Shop
Brand New
Favorites
Clearance
Bestsellers
Designer Tools
News
Grant
FAQ
Corrections
Downloads
Article Archives
Site Map
Bead Shop
Catalogs
Coupons
Newsletters
Trend-E-Mails
Contact & About Us
Order Terms
International Terms
Términos y Condiciones
|
|
| |
Step 1: Start with the length of the Beading wire you would like your necklace to be.
Step 2: Follow the same order till you get to the length of the necklace you would like.
Step 3: Start in the center or middle of your necklace. Take the S2.5 - TK151001 coil bead -
WC20N run SHP22 headpin into whole just half way so you can put the B53014SQ in center of the Circle -
TK121001 - S2.5. Loop the headpin and thread wire into loop. This will be the center of your Necklace.
Step 4: Now start beading on each side so they match. Tube TK194001 - Cap TK152001 - 8mm Bead
CH8SQ - Cap TK152001- TK130073- Granular Bead - WS9S Pearl Saucer - do this three times. Cap TK152001-
CH8SQ - TK152001- TK117001 7x8mm Turkish Bead - Tube TK194001 - TK117001. Repeat this pattern two or
three times depending on the length you would like.
Step 5: End with the same pattern only omitt two of the WS9N pattern so you only have one and
repeat the same bead pattern as above.
Step 6: Finish with the Crimp SCT1 on to the Toggle TK282042 and Bar. Finsh with the SB093 Crimp
cover.
|
|