EZ Shop
Brand New
Favorites
Clearance
Bestsellers
Designer Tools
News
Grant
FAQ
Corrections
Downloads
Article Archives
Site Map
Bead Shop
Catalogs
Coupons
Newsletters
Trend-E-Mails
Contact & About Us
Order Terms
International Terms
Términos y Condiciones
|
|
| |
Step 1: Take around a 26 inch piece of beading wire.
Step 2: Start in the center by putting four of the SB161- (Faceted Rounds) place the TK181032 - ring in
center setting on the SB161's.So it can slide freely.
Step 3: TK130071-(Little Heishe) Then pearls of you choice -Vary the colors listed above. Also vary the
silver Heishe between each pearl.
Step 4: Make sure to match each side of the necklace.
Step 5: Finish off ends by putting the Toggle ring and Bar on necklace. Uwe the SCT1 - crimp tube and
cover with crimp cover - SB093.
Step 6: In center of the necklace on the TK181032 twisted ring place the following on it.
a. The SF072- eyepin. Place the SB161-faceted round - round pearl - SB161.
b. Take the chain 22207F - one inch and attach to the ring of the eyepin.
c. Place various pearls and faceted rounds - SB161 and TK130071 small heishe on the SHP23 - 3 inch headpin.
Make each headpin different.Wrap each headpin on chain.
d. For a different effect do a wire wrap bail with the XCT9W - top drill coin pearl. You may use a 24 gauge
wire or the SHP23 - 3 inch headpin.
e. Also you can use the silver leaves - SM1643 with a pearl and heishe.
Place all of the above on headpins and attach to the chain on various links.
|
|